2022-02-01 – POST BEING RE-Edited

January 2022

I’ve decided to redo this post to include as much detail on the z1a Engine Rebuild/Restoration. As it is now January 2022, the engine is almost fully assembled and almost ready to install back in the running frame. Leaving only a Battery, Exhaust and Paint Job to complete it

History

Looking back through my notes I acquired the z1a in 2005 for around $1400AUD (with spare engine parts) and had it stored for many years. The engine starting point is shown below. It had been customized at some point as it had bits of chrome and paint where the factory engine didn’t. it looked pretty sad but was all there.

Removed from the engine, years of neglect show through.

Assembly

The Strip down process documented for the z900A4 also applies to the z1a so I wont repeat it here, however the engine case cleanup came up trumps with no visible damage anywhere in the bores or in the head. A test fit to see

Final Assembly

The completed engine cases after water blasting (technically NOT Vapor Blasting as that is a different final finishing process using different medium I am told).